Technical data

12
W&T
Power-over-Ethernet
The W&T Web-IO Analog-In/Out can obtain its supply voltage
through the network interface in accordance with IEEE802.3af /
Power-over-Internet. The feed comes in over the data pairs or
on the wire pairs not used for 10/100BaseT (see PoE section).
1.4 Assigning the IP address using „WuTility“
Once the hardware has been connected to the power supply as
described above, the IP address needed for operating in a TCP/
IP network must be assigned. You should obtrain the correct
value for this parameter from your systems administrator.
!
The IP address must be unique in the network.
There are various ways of assigning the IP address. To make
the procedure as convenient as possible, we have developed
the „WuTility“ tool, which you can download from the WuT
homepage at http://www.wut.de. This procedure is described
in the following. A summary of the options for assigning the IP
address can be found in the Appendix of this manual.