Technical data

106
W&T
/ : Interval within the entered range, e.g. minute „0-45/2“
triggers the timer in a range between the 0th and 45th minute
every two minutes (0, 2, 4, 6 ,8, 10, ... , 44).
, : Indicates an absolute value. For example: Minute 0. 15, 30
triggers the timer at each full hour, at the 15th minute and at
the 30th minute.
Note: All fields must be filled in for the times to be accepted.
When the device detects invalid character combinations, it
outputs a question mark and rejects the time. If the entries
exceed the allowed numerical range, the time is also rejected.
An action does not then take place.
If the alarm conditions are met, an alarm is generated when the
start time is reached. If the trigger conditions are yet met when
the stop time is reached, the alarm is reset.
Alarm monitoring can be shown in the graphic on the Home
page: Stop – Config – Enable alarm monitoring display.
Example:
In the following example the alarm monitor is enabled from
Monday through Friday at 08:00 and disabled from Monday
through Friday at 17:00. Outside of these times no alarm is
shown or triggered.
Enable: Select the type of message. For an e-mail alarm activate
the „Mail enable“ checkbox“.