Technical data

102
W&T
Scale:
The following parameters can be associated with the scale:
unit: The unit to be shown for this scale.
min: The lower value shown for this scale
max: The upper value shown for this scale
auto scale: The lower and upper values for this scale are
automatically selected based on the measurement values, so
that an optimal, dynamic representation can be achieved. If this
function is enabled, the „min“ and „max“ parameters are
ignored.
auto fit: If this function is enabled the scale is corrected so that
only whole-number values are shown on the display grid. Auto
fit automatically enables the auto scale function.
Slider:
The following parameters can be applied to the sliders for direct
access using the Control page:
Pixel: Length of the slider in pixels
Start: Lowest value that can be set using the slider.
End: Highest value that can be set using the slider.