Technical data

10
W&T
1.2.3 Current output 0..20mA (#57661)
Note: Current outputs cannot be connected directly to active
inputs. Please use isolation amplifiers.
If you need to connect two passive sensors, 1.1 and 2.1 may
be jumpered in order to save wires. 1.2 and 2.2 may not be
jumpered however, since otherwise cross-currents will flow
which falsify the input values.
1.2.4 Voltage input 0..10V (#57662)
1.2.5 Voltage output (#57662)
The voltage output must be jumpered to the Sense input, which
can be used to measure and regulate the output voltage. This
jumper can be made either directly on the device or at the
remote end. Imax in both cases 15mA at sense line.