User manual

23 User manual
4.7. MANUAL STOP
If needed, the cycle can be interrupted at any moment by pressing the "STOP" key for 2 seconds. An audible tone will
confirm the request…
…This is followed by a phase of approximately 2 minutes, required to reinitialise the system and return the chamber to
atmospheric pressure.
The door can be opened when the "Exit" key appears on the display at the end of this phase.
The load is not sterile and the cycle must be repeated !
2”
M A N U A L S T O P
L O A D N O T
P L E A S E W A I T
S T E R I L E
If the cycle is interrupted after the PR phase (plateau period), following message will be
displayed and printed : !! LOAD STERILIZED, BUT NOT DRIED !!
!! FOR IMMEDIATE USE ONLY !!