Specification and User Manual - 20210906

Please refer to the Vzense_ConfigTool_User_Guide.pdf.
The slave trigger mode can be used to implement multiple products synchronization,
one works as master, the other works as slave.
Please refer to Multiple_ToF_Products_Synchronization_Application_Note.pdf for
more information.
7.2 Range Customization
By default, there are 3 different range modes calibrated for DCAM710, please see
below table for more information:
Range number
Distance range
Range 0
0.35m~1.5m
Range 1
0.5m~2.8m
Range 2
0.8m~4.4m
Please do NOT use uncalibrated modes, the measurement data will not be guaranteed.
If you need other range mode requirement, you can ask Zense team to do range
customization, reasonable NRE fee will be charged.
One range mode of the Zense DCAM710 camera can fulfill furthest distance be at most
5 times of nearest distance. For example, if the near limitation is 0.4m, then the furthest
distance in this mode can reach about 2m.
7.3 Wide Dynamic Range
As mentioned above, Most of the ToF based 3D sensing technology has range
limitation to nearest and furthest distance, due to the sensor saturation of weak light
strength to far objects. One range mode of the Zense DCAM710 camera can fulfill
furthest distance be at most 5 times to nearest distance. For example, if the near
limitation is 0.4m, then the furthest distance in this mode can reach about 2m.
0
0.005
0.01
0.015
0.02
0.025
250
400
600
800
1000
1200
1400
1600
1800
2000
2200
2400
2600
2800
3000
3200
3400
3600
3800
4000
4200
DISTANCE ERROR
DISTANCE RANGE UNIT MM