DCAM560C ToF Camera User Manual -20211210

1. Mount the camera in an appropriate fixture, e.g. a camera bracket;

2. Connect the DCAM560 Lite ToF camera to the host processor with the Ethernet

cable(VZENSE-LAN-CAT5e-CABLE), the standard RJ45 socket locates at the back of

the DCAM560 Lite camera;

3. Insert the DC connector of the power supply adaptor into the 12V DC Jack at the

back of the camera;

4. Connect the adaptor to power source;

5. Please do set the IP address of the camera and host PC in the same segment;

6. The default IP address of DCAM560 Lite is 192.168.1.101, you can change the IP

address by the VzenseConfigTool;

China：https://gitee.com/Vzense/VzenseConfigTool

Oversea：https://github.com/Vzense/VzenseConfigTool

Please do read the document before reconfigure the camera:

6.1.3 POE Mode Installation (For DCAM560C Pro)

What is POE (Power Over Ethernet)

Power over Ethernet (POE) is a technology that lets network cables carry electrical

power.

For example, a digital security camera normally requires two connections to be made

when it is installed:

A network connection, in order to be able to communicate with video recording and

display equipment.

A power connection, to deliver the electrical power the camera needs to operate.

However, if the camera is POE-enabled, only the network connection needs to be

made, as it will receive its electrical power from this cable as well.