DCAM560C ToF Camera User Manual -20211210
16
T1
Exposure Exposure
EXT_Trigger
Camera Exposure
T1
The requirement to T1 should be from 100us to 2ms.
Exposure_timing Pin Description
This pin is an output indicates the whole exposure period of the camera. The internal
circuit of this pin with a pull-up resistor 430Ω.The pull up voltage is 5V. At low level,
the pull-down resistor is 100Ω.
By default, the polarity is low level activated, which means a low-level signal indicates
the exposure period. Please refer to below figure:
Exposure
Exposure
Exposure_timing Pin