DCAM550 ToF Camera User Manual 2022

26
USB HUB ToF Camera
Power Adaptor
PC
You can contact the Vzense team ([e-mail]) for the external powered USB
HUB.
6.1.3 100M Ethernet Installation (DCAM550-P and DCAM550-E)
In this mode, the camera transmits the required data to host by Ethernet cable, so the
power adaptor shall be used.
The steps are as below:
1. Mount the camera in an appropriate fixture, e.g. a camera bracket;
2. Connect the DCAM550-P or DCAM550-E ToF camera to the host processor with the
Ethernet cable(VZENSE-LAN-CAT5e-CABLE), the standard RJ45 socket locates at
the back of the DCAM550-P or DCAM550-E ToF camera;
3. Insert the DC connector of the power supply adaptor into the 12V DC Jack at the
back of the camera;
4. Connect the adaptor to power source;
5. Please do set the IP address of the camera and host PC in the same segment;
6. The default IP address of DCAM550-P or DCAM550-E is 192.168.1.101, you can
change the IP address by the VzenseConfigTool;
China：https://gitee.com/Vzense/VzenseConfigTool
Oversea：https://github.com/Vzense/VzenseConfigTool
Please do read the document before reconfigure the camera: