User's Manual

System Configuration Guide
www.vyyo.com
Adding a Modem to the XMTS – p. 72
8. Type “goto_ds xxxxxxxxx” to set the Downstream Frequency, where “xxxxxxxxx”
is the frequency in Hertz.
NOTE: Your system engineer should provide you with
this value. This will now be the permanent fixed
frequency at which the modem will listen for a broadcast
from the XMTS. After a maximum of 30 seconds, the
modem LEDs should light up and remain lit. This
indicates that the modem has locked on to the
Downstream channel, is operating on the appropriate
Upstream channel, and is authorized for operation on the
XMTS.
Figure 5-37: Setting the Frequency to 743 Mhz (or 743000000, i.e., six zeroes)
Enter the frequency here