User's Manual

System Configuration Guide
www.vyyo.com
Adding a Modem to the XMTS – p. 57
5.3 Configuring the XMTS
NOTE: Before you can perform this procedure you must
have previously edited the regtree.txt file, compiled it and
downloaded it to the XMTS to set its IP address. See
Setting the XMTS IP Address.
This section assumes that you have previously installed
NMS Version 5.0. See Installing and Uninstalling the
NMS for instructions.
The upstream and downstream channels of the XMTS must be configured before
a modem can communicate with the XMTS.
5.3.1 Setting the XMTS Upstream Parameters
1. Open the Network Management System and double-click on the XMTS
icon to bring up the Network display of the XMTS front panel:
Figure 5-21: Network display of the XMTS
Double click this icon