User's Manual

Vyyo Installation Guide
www.vyyo.com
Checking the XMTS Version – p. 140
2. Now click on “Connect” in the main window and when the popup
menu appears, verify or set the IP address as needed, and click on
“Connect” then “Close”. A message will appear in the main window
indicating if the connect command was sent.
NOTE: the “Activate” command automatically closes the
XMTS connection after approximately 60 seconds – this
may cause a message like “Inconsistent WMTS Version”
to appear in the message window. If this occurs just right
click and select “Activate” again then “Connect” then
“Version Check (WMTS)”.
Figure B-2: Connecting to the XMTS