User's Manual

Vyyo Installation Guide
www.vyyo.com
Synoptics Display for XMTS Configuration – p. 128
Chapter 11. Synoptics Display for
XMTS Configuration
This chapter explains how to use the older Synoptics Display interface to set upstream
and downstream parameters for the xTMS.
NOTE: Before you can perform this procedure you must
have previously edited the regtree.txt file, compiled it and
downloaded it to the XMTS. See Setting the XMTS IP
Address.
This procedure is to be used only if you cannot configure
the XMTS using the Vyyo Configuration tool as described
in 5.3 Configuring the XMTS.
11.1 Setting the XMTS Upstream Parameters
1. Open the Network Management System and double-click on the XMTS
icon to bring up the Network display of the XMTS front panel: