User's Manual

Vyyo Installation Guide
www.vyyo.com
Setting the XMTS IP Address – p. 102
Chapter 7. Setting the XMTS IP
Address
Note: Prior to performing this procedure the XMTS must
be connected to the “download” computer serial port via
the lower COM port (COM2) on the XMTS Control and
Forward card.
The XMTS must also be connected to the same LAN
subnet as the computer using its RJ45 connector on the
same card.
Tip: This procedure may also be used to download other
files to the XMTS, such as software downloads.
The wmtsConfig.exe tool is used to set a temporary IP address for
the XMTS. This IP address allows the XMTS to appear on the LAN
subnet and communicate with the servers (which are on the same
network).
Next, we will be modifying regtree.txt to contain the permanent XMTS
IP address, then compiling regtree.txt into regtree.rtr and downloading
it. The download is made by specifying regtree.rtr in the “Version File”
field of the wmtsConfig.exe tool and making sure that regtree.rtr is
copied into the TFTP file transfer folder.
14. Locate the file “regtree.txt” and open it using a standard text editor
such as Notepad. Scroll down (or use the “Find” function from the menu)
to the entry “CmtsIPAddress” which is shown as 10.10.10.210 in this
example. The default network address for Vyyo equipment is
10.10.10.xxx. Your system engineer should be able to provide the
addresses and other parameters you need to configure the XMTS.
15. Change the “CmtsIPAddress” as desired: this is the XMTS’s
permanent IP address which will be downloaded in the next step.
16. Change the two lines immediately following this line if necessary: the
“GatewayIPAddress” (the address of the gateway computer or router)
and the “CmtsSubnetMask”.
17. Change DevNMAccessIP1 and DevNMAccessCommunity for
remote control as appropriate in Regtree.txt. Up to five IP addresses may
be defined here. If you wish to add additional remote computers:
duplicate the three lines for DevNMAccessIP1 and
DevNMAccessCommunity1 and DevNMAccessControl1 for each
additional remote computer, change the numbers so that you have
DevNMAccessIP2, DevNMAccessCommunity2,