User's Manual

Vyyo Installation Guide
www.vyyo.com
Setting the WMTS IP Address – p. 94
• WMTS IP address
• Gateway computer (used for downloading) IP address
• Gateway computer subnet mask
• IP addresses of any other computers that are permitted to
access the WMTS remotely
2. Change the “CmtsIPAddress” as desired: this is the WMTS’s
permanent IP address which will be downloaded later using the
XmtsConfig tool.
3. Change the two lines immediately following this line if necessary: the
“GatewayIPAddress” (the address of the gateway computer or router)
and the “CmtsSubnetMask”.
4. Change DevNMAccessIP1 and DevNMAccessCommunity for remote
control as appropriate in Regtree.txt. Up to five IP addresses may be
defined here. The first one should be the same as that of the Gateway
computer or router used in the previous step. If you wish to add
additional remote computers: duplicate the three lines for
DevNMAccessIP1 and DevNMAccessCommunity1 and
DevNMAccessControl1 for each additional remote computer, change
the numbers so that you have DevNMAccessIP2,
DevNMAccessCommunity2, DevNMAccessControl2 for the second
computer and so forth up to the fifth remote computer. Then change the
corresponding IP addresses for DevNMAccessIP2 and so forth.
Note: No other edits should be necessary in this file,
although the default frequencies for all the upstream and
downstream channels are initialized in this file and may
be changed if necessary.