User's Manual

Vyyo Installation Guide
www.vyyo.com
Checking the WMTS Version – p. 124
33. Now click on “Connect” in the main window and when the popup menu
appears, verify or set the IP address as needed, and click on “Connect”
then “Close”. A message will appear in the main window indicating if the
connect command was sent.
NOTE: the “Activate” command automatically closes the
WMTS connection after approximately 60 seconds – this
may cause a message like “Inconsistent WMTS Version”
to appear in the message window. If this occurs just right
click and select “Activate” again then “Connect” then
“Version Check (WMTS)”.
Figure B-2: Connecting to the WMTS