User's Manual

Vyyo Installation Guide
www.vyyo.com
Setting the WMTS IP Address – p. 102
13. Now enter the TFTP Server IP Address, Subnet mask and Default
Gateway. Click the corresponding buttons as you set each of these.
Observe that the caption at the top of the XmtsConfig tool indicates
“Connected: Com 1” at this time since it is connected via the serial
connection. After the IP address has been set, the caption will change to
“Connected: Remote 10.10.10.202” in this example (see the next step) to
indicate that the LAN connection is active.
NOTE: If the permanent IP address of the WMTS is
working you may connect (in the previous step) using it
instead of the serial port by choosing “IP” instead of
“Serial”. The WMTS is shipped with the default IP
address of 10.10.10.2. If you do use the IP connection
you may skip this step.
Figure 7-9: Setting the WMTS temporary IP address
Setup these
three items