User's Manual

Page Center User Manual
Page 19
deactivate a pager. Once the pager number for this group is set, press the F1 button. The following prompt
will appear.
GROUP X = numeric
SELECT GROUP FUNC
4. Using the arrow keys, select the function (numeric, alpha or tone) for this pager group. Members of the
group may be of any type, but this selection will determine the prompt to the user when a page to this group
is initiated. Press F1 when your selection is made. The display will change to :
GROUP X MEMBER NN
ENTER MEMBER NUMBER
5. X will be the group number you are currently working on, and NN will be a number corresponding to the
member number you wish to edit. The first group member you enter will be member 1. The second one
you enter will be member 2 and so on. The display always first shows the next member number you can
enter a new member as. Use the UP/DOWN arrows if you wish to scroll through the members, or press the
DEL key to edit the member number and manually enter the member number to edit. Press F1 key when
you are ready to edit/add the selected group member. The display will then show:
MEMBER NN =
ENTER PAGER NUMBER
6. Enter the number of the pager you wish to add to the group. For example if you wish to add pager number
123 to the group, then enter 1 2 3 and then press the F1 key. Use the DEL key to backspace over any entry
if you wish to edit it. Note that:
• To see the pagers in the database are members of this group, you can use the UP/DOWN arrow key to
scroll through the members of the group.
• To delete a member, at the MEMBER NN = prompt, use the DEL key to erase its number from the
screen, and press the F1 key.
7. To finish entering pagers to this group, press the - key.
5.3 Sending Test Pages
The test page mode may be used to check the range of the system. With this mode, the PAGE CENTER will
automatically generate a page to pager number "0" every ten seconds.
1. Before using this feature, pager number "0" must be programmed as described above.
2. To enable this feature, enter the program mode and press 3. The display will show:
PAGING pAGEr 0
dash (-) to exit
3. Press the - key to return to the programming mode menu.
5.4 Alarm Pages
The PAGE CENTER has 8 alarm inputs. These digital inputs are used to generate pre-programmed pages, each
with its own pre-programmed message to any pager, or group of pagers. These may be used for alarms, but they
may also be used to simply generate pre-programmed pages.
The inputs may be connected to normally-open switches or contacts. When any input is pulled low to ground, it
will generate a pre-programmed page. When any input is pulled high or allowed to "float high", it will generate
a different pre-programmed page.