User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 56 7M487C4
Oper1
THreshold NOMDPSatrx
[ 1…32767 ]
Set or display the alarm threshold in minutes of no MDP packets received from the
Satellite Receiver.When the number of minutes exceeds this value, the
noMDPSatRx
alarm will trigger.
Oper1
THreshold NOMDPLan
[ 1…32767 ]
Set or display the alarm threshold in minutes of no MDP packets received from the LAN.
When the number of minutes exceeds this value, the
noMDPLan
alarm will trigger.
Oper1
THreshold Freerunningtimeout
[ 1…256 ]
Set or display the free running timeout alarm threshold in minutes. When no 1 PPS
signal is received from the GPS within this timeout period, the
freeRunning
alarm will
trigger. The
freeRunning
alarm will clear when a 1PPS signal is received from the GPS.
Oper1
THreshold TRaplevel
[ OFF | INFO | MINOR | MAJOR | CRITICAL ]
Set or display the SNMP trap message severity level threshold. Alarm events that are
configured to generate SNMP trap messages will only send a message if the
corresponding severity level is equal to or greater than this setting. When this value is set
to
OFF
no SNMP trap messages will be sent.
Oper1
THreshold Gpstimeout
[ 1…32767 ]
Set or display the GPS data timeout alarm threshold in seconds. The
gpsNoData
alarm
will trigger when no valid GPS protocol data units have been received on the GPS
interface for this period of time.
Oper1
THreshold Usersessions
[ 0…6 ]
Set or display the user sessions threshold. The
userSessionsExceeded
alarm will trigger
when the number of active sessions (both console and Telnet) exceeds this value. The
userSessionsExceeded
alarm will clear when the number of sessions drops to this value
or below.
Oper1
THreshold Sessionidletimeout
[ 1…256 ]
Set or display the session idle threshold in seconds. The
sessionTimeout
alarm will
trigger when the idle time of an active session (both console and Telnet) exceeds this
value. The
sessionTimeout
alarm will clear when an active user session is terminated by
a correct exit sequence.
Oper1
THreshold Dekeytimeout
[ 1…256 ]
Set or display the dekey timeout threshold in minutes. The
dekeyTimeout
alarm will
trigger when the station dekeyed exceeds this value. The
dekeyTimeout
alarm will clear
when the station is keying.
13.2.21 TRAC
E
…
Enable various diagnostics output to either the “admin” telnet session console, or if not
opened to the front panel console port. NOTE: Only one trace can be active at one time and
trace states are not saved (always comes up from a power-on or reset with all trace messages
turned off).
TRAC
e Frame
[ YES | NO ]
Set or display the state of the Frame timing message.