User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 53 7M487C4
Display the current of the specified power amplifier power supply in Amps. The returned
value will be a number between 0 and 50.
Oper1
PS
[ 1…4 ]
Enable
[ YES | NO ]
Set or display the state of the specified power amplifier power supply. A
YES
value
implies that the power supply is enabled, a
NO
value implies that the power supply is not
enabled.
PS
[ 1…4 ]
Overcurrent
Display the overcurrent status of the specified power amplifier power supply. The
returned value will be
PASS
or
FAIL
.
PS
[ 1…4 ]
Status
Display the overall status of the specified power amplifier power supply. The returned
value will be
PASS
or
FAIL
.
PS
[ 1…4 ]
Voltage
Display the voltage of the specified power amplifier power supply in Volts. The returned
value will be a number between 0 and 54.
13.2.16 PW
RSUPPLY
…
The following are the commands relating to the station power supply settings.
PW
rsupply Acstatus
Display the AC power status of the power supply. The returned value will be
AC
or
BATTERY
.
PW
rsupply Currstatus
Display the current status of the power supply. The returned value will be
FAIL
or
PASS
.
PW
rsupply Fanstatus
Display the fan status of the power supply. The returned value will be
FAIL
or
PASS
.
PW
rsupply Overallstatus
Display the overall status of the power supply. The returned value will be
FAIL, OK
or
PROBLEM
.
PW
rsupply Tempstatus
Display the temperature status of the power supply. The returned value will be
FAIL
or
PASS
.
13.2.17 R
ESET
…
The following is the command and options relating to resets.
Oper1
Reset
Perform a cold reset on the system..