User Manual
Table Of Contents
- FOREWORD
- GENERAL OVERVIEW
- SPECIFICATIONS
- ELECTRICAL REQUIREMENTS
- SITE PLANNING
- INSTALLATION
- OPERATION
- POWERING UP THE SYSTEM
- CONNECTING A TERMINAL
- Bootloader
- *************************
- G2BT BOOTLOADER
- Version 2F49405
- *************************
- Current MAC address = 00:01:02:03:04:05
- Current IP address = 11.31.3.4
- Current subnet = 255.255.255.128
- Current gateway = 11.31.3.126
- Current TFTP Server = 10.0.0.1
- Current Download File = g2bt.pkg
- ***You've got 5 seconds to escape normal boot process by entering any key...
- Loading application...
- Application
- QUICK-START CONFIGURATION
- SUBSYSTEMS
- USER INTERFACES
- SW DOWNLOAD PROCESS
- POWER CONTROL
- COMMAND LINE USER INTERFACE
- ALARMS AND MANAGEMENT
- FACTORY DEFAULT VALUES
Sonik G2BT Base Transmitter User Manual
March 14, 2002 52 7M487C4
Display the number of Power Amplifiers installed in the station transmitter.
PA
Operational
Display the number of Power Amplifiers in the station that are currently operational.
PA
[ 1…4 ]
Attenlevel
Display the attenuation level of the specified Power Amplifier.
PA
[1…4 ]
Current
Display the DC supply current in Amps of the specified Power Amplifier.
Oper1
PA
[ 1…4 ]
Enable
[ YES | NO ]
Set or display the state of the specified power amplifier. A
YES
value indicates that the
power amplifier is enabled, a
NO
value indicates that the power amplifier is not enabled.
PA
[ 1…4 ]
Fanstatus
Display the fan status of the specified Power Amplifier. The returned value will be
FAIL
or
OK
.
PA
[ 1…4 ]
ONline
Display the online status of the specified Power Amplifier. The returned value will be
YES
or
NO.
PA
[1…4]
OUtputpwr
Display the output power in Watts of the specified Power Amplifier.
PA
[1…4]
OVerdrivestat
Display the overdrive status of the specified Power Amplifier. The returned value will be
OK
,
PROBLEM
or
FAIL
.
PA
[1…4 ]
Rfltdpwr
Display the reflected power in Watts of the specified Power Amplifier.
PA
[ 1…4 ]
TEmperature
Display the temperature in degrees Celsius of the specified Power Amplifier.
PA
[ 1…4 ]
THermalstatus
Display the thermal status of the specified Power Amplifier. . The returned value will be
OK
,
PROBLEM
or
FAIL
.
PA
[1…4 ]
Voltage
Display the DC supply voltage in Volts of the specified Power Amplifier.
13.2.15 PS…
PS
[ 1…4 ]
Acsense
Display the AC power status of the specified power amplifier power supply. The returned
value will be
PASS
or
FAIL
.
PS
[ 1…4 ]
Current