User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 51 7M487C4
Set or display the transmitter host name. The host name can be up to 16 characters.
Oper1
Network Lan Ipaddr
[ a.b.c.d ]
Set or display the IP address of the Ethernet LAN link in Internet dot notation.
Oper1
Network Lan Subnet
[ a.b.c.d ]
Set or display the IP address subnet mask of the Ethernet LAN interface for this device in
Internet dot notation.
N
etwork Lan Macaddr
Display the Ethernet LAN MAC address.
N
etwork Telnet ADMINName
[ name ]
Set or display the Telnet administrator name.
N
etwork Telnet ADMINPassword
[ password ]
Set or display the Telnet administrator password.
Oper1
Network Telnet OPER1Name
[ name ]
Set or display the specified Telnet operator name.
Oper1
Network Telnet OPER1Password
[ password
]
Set or display the specified Telnet operator password.
Oper1
Network Telnet OPER2Name
[ name ]
Set or display the specified Telnet operator name.
Oper1
Network Telnet OPER2Password
[ password
]
Set or display the specified Telnet operator password.
Oper1
Network Telnet OPER3Name
[ name ]
Set or display the specified Telnet operator name.
Oper1
Network Telnet OPER3Password
[ password ]
Set or display the specified Telnet operator password.
Oper1
Network Telnet Idletimeout
[ 0…86400]
Set or display the Telnet inactivity timeout in seconds. Setting this value to zero disables
the session inactivity timeout function. Any other setting will abort user sessions after the
configured number of seconds expires with no input from the user.
Oper1
Network Telnet Sessions
Display the number of currently active user sessions. NOTE: The number of Telnet
sessions is limited to 5, so that this parameter cannot exceed 6 (it includes the front panel
console if active). Also note that only one active “admin” session is allowed.
13.2.14 PA…
The following are the commands relating to the Power Amplifier settings.
PA
Installed