User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 50 7M487C4
Displays the latitude reported by position device in radians (degrees, minutes, seconds).
G
ps LOngitude
Displays the longitude reported by position device in radians (degrees, minutes, seconds).
G
ps SAtellite Tracked
Displays the number of tracked satellites.
G
ps SAtellite Visible
Displays the number of visible satellites.
G
ps SYnc
Displays the current state of the timing synchronization status. This information is the
equivalent of the Sync LED; the returned values will be “OFF” (Sync LED off),
“SEARCHING” (Sync LED red), “TRACKING” (Sync LED red), “LOCKED” (Sync
LED green) or “HOLDING” (Sync LED orange).
13.2.12 L
OG
…
The following are the commands relating to the Alarm logs.
L
og Clear
Display the list of alarms that have been cleared.
L
og Curr
Display the list of all currently active alarms.
L
og HIGhest
Display the worst case active alarm condition. The return value could be
CRITICAL,
MAJOR, MINOR, INFO
.
L
og HIStory
Display the list of all alarm history information.
L
og Last
Display the last send alarm.
L
og Sent
Display the number of alarms that have been sent.
13.2.13 N
ETWORK
…
The following are the commands relating to the Ethernet LAN or Telnet settings.
Oper1
Network Gateway
[ a.b.c.d ]
Set or display the IP address of the default gateway in Internet dot notation. This is the
address of the default network device to route packets through that are not immediately
addressable on the Ethernet LAN.
Oper1
Network Host
[ hostname ]