User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 49 7M487C4
Set or display the tranlin training interval in minutes. A value of zero indicates training at
every keyup. A value of
NOW
indicates training will take place at the next available key
point (the set numerical value will not be altered).
13.2.9 EXI
T
This command will end the user session.
13.2.10 F
LASH
...
The following are the commands relating to the firmware contained in flash memory.
Oper1
Flash Default
Restore the configuration to the factory default settings. NOTE: This does not
automatically save the default settings in Flash; a “FLASH SAVE” must also be entered
to achieve that.
Oper1
Flash Restore
Restore the configuration from Flash memory.
Oper1
Flash Save
Save the current configuration to Flash memory.
F
lash View
Display the configuration in Flash memory.
13.2.11 G
PS
...
The following are the commands relating to the GPS settings.
G
ps Model
Display the model of the GPS.
G
ps STatus
Display the status of the GPS device driver. When no GPS is connected or the device is
not operating this command will return “NO SIGNAL”. When the GPS device is
operating but does not have adequate satellite visibility, is in power up search mode, or
cannot resolve an adequate time fix this command will return “SEARCHING”. When the
GPS device is reporting accurate timing information this command returns “GOOD”.
Gps Altitude
Displays the altitude reported by position device in meters.
G
ps Dop Type
Displays the Dilution-Of-Precision type. The value will be either PDOP (3D) or HDOP
(2D).
G
ps Dop Value
Displays the Dilution-Of-Precision value. This will be a number between 0 and 999, each
number representing a 0.1 resolution.
G
ps LAtitude