User Manual
Table Of Contents
- FOREWORD
- GENERAL OVERVIEW
- SPECIFICATIONS
- ELECTRICAL REQUIREMENTS
- SITE PLANNING
- INSTALLATION
- OPERATION
- POWERING UP THE SYSTEM
- CONNECTING A TERMINAL
- Bootloader
- *************************
- G2BT BOOTLOADER
- Version 2F49405
- *************************
- Current MAC address = 00:01:02:03:04:05
- Current IP address = 11.31.3.4
- Current subnet = 255.255.255.128
- Current gateway = 11.31.3.126
- Current TFTP Server = 10.0.0.1
- Current Download File = g2bt.pkg
- ***You've got 5 seconds to escape normal boot process by entering any key...
- Loading application...
- Application
- QUICK-START CONFIGURATION
- SUBSYSTEMS
- USER INTERFACES
- SW DOWNLOAD PROCESS
- POWER CONTROL
- COMMAND LINE USER INTERFACE
- ALARMS AND MANAGEMENT
- FACTORY DEFAULT VALUES
Sonik G2BT Base Transmitter User Manual
March 14, 2002 48 7M487C4
Oper1
DOwnload Mode
[ OFF | NOW | TIMED ]
Set or display the remote software download mechanism. A value of
OFF
indicates
software downloads cannot be done remotely. A value of
NOW
will start a download
immediately. A value of
TIMED
indicates the station will begin making TFTP file
requests of the specified filename at the time specified to the specified server IP address.
Oper1
DOwnload SErver
[ a.b.c.d ]
Set or display the TFTP Client mode server IP address in Internet dot notation.
Oper1
DOwnload File
[ filename ]
Set or display the TFTP download file name.
Oper1
DOwnload TIME
[ YYYY:MM:DD HH:MM:SS
]
Set or display the TFTP Client mode download date and time.
Oper1
DOwnload TIMEOut
[0…4294967295 ]
Set or display the TFTP download timeout in milliseconds. This value indicates the
amount of time the station will wait after it has sent an acknowledge (or error) packet for
the next packet to arrive.
Oper1
DOwnload Interval
[0…4294967295 ]
Set or display the TFTP packet interval in milliseconds. This value indicates the time
between packet receipt and packet acknowledgement.
Oper1
DOwnload Retries
[0…4294967295 ]
Set or display the TFTP download retries. This value indicates the number of error
packets the station will send before it will abort the download session.
DO
wnload Packets Received
[ 0…4294967295 ]
Display the TFTP Client mode download packets received (successfully or not).
DO
wnload Packets Programmed
[ 0…4294967295 ]
Display the TFTP Client mode download packets successfully received.
Oper1
DOwnload Xmodem
[filename ]
Set or display the XMODEM/YMODEM uploaded filename from the local front panel
serial port. If a filename is specified, this implies that a local file upload is being initiated.
Oper1 Oper2
DOwnload TRACe
[ YES | NO ]
Set or display the software download trace status. The trace status sends out status
information to the front panel console.
13.2.8 EXC
ITER
...
The following are the commands relating to the station exciter settings.
EXC
iter Intselftest
Display the station exciter internal self-test results. The returned value will be
PASS
or
FAIL
.
EXC
iter Traininterval
[ NOW | 0…60 ]