User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 47 7M487C4
Set or display the distribution upper hysteresis CRC limit for good HDLC frames
received. The parameter is a percentage of good HDLC frames received.
Oper1
DIstribution Hdlc NUmcrcframes
[ 0…30000 ]
Set or display the distribution HDLC frames CRC error measurement. The parameter is
the computational interval in frames.
Oper1
DIstribution Hdlc NEtzone 1
[ 0…65536 ]
Set or display the distribution network zone address 1.
Oper1
DIstribution Hdlc NEtzone 2
[ 0…655
36 ]
Set or display the distribution network zone address 2.
Oper1
DIstribution Hdlc NEtzone 3
[ 0…65536 ]
Set or display the distribution network zone address 3.
Oper1
DIstribution Hdlc NEtzone 4
[ 0…65536 ]
Set or display the distribution network zone address 4.
Oper1
DIstribution Hdlc NEtzone Mask
[ 0…65536 ]
Set or display the distribution network zone address mask.
DI
stribution Satrx NETUnitaddr
Display the Satellite receiver network unit address.
DI
stribution Satrx Swver
Display the Satellite Receiver SW Version.
DI
stribution Satrx PRimarycarrierfreq
[ 950…1450 ]
Set or display the Satellite Receiver primary carrier frequency in MHz.
DI
stribution Satrx Lnbcontrolmode
[ OFF | ON ]
Set or display the Satellite Receiver Low-Noise Block (LNB) mode.
DI
stribution Satrx POrtsetting
[ RS232 | RS485 ]
Set or display the Satellite Receiver port settings.
DI
stribution Satrx Installed
Display whether the Satellite Receiver is installed. The returned value will be
YES
or
NO
.
DI
stribution Satrx Alignment Level
Display the Satellite Receiver alignment level. The returned value will be between 0 and
65536.
DI
stribution Satrx Alignment Mode
[ OFF | ON ]
Set or display the Satellite Receiver alignment tone mode.
13.2.7 D
OWNLOAD
…
The following are the commands relating to software downloads.