User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 46 7M487C4
Set or display the console port user interface inactivity timeout period in seconds. Setting
this value to zero disables the session inactivity timeout function. Any other setting will
abort user sessions after the configured number of seconds expires with no input from the
user.
Oper1 Oper2
COnsole Baud
[ 300 | 600 | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200
]
Set or display the baud rate operating on the front panel RS-232 serial console port.
Oper1 Oper2
COnsole Databits
[ 7 | 8 ]
Set or display the number of data bits per asynchronous symbol transmitted and received
on the front panel RS-232 serial console port.
Oper1 Oper2
COnsole Stopbits
[ 1 | 2 ]
Set or display the number of framing stop bits per asynchronous symbol transmitted and
received on the front panel RS-232 serial console port.
Oper1 Oper2
COnsole Parity
[ NONE | ODD | EVEN | SPACE | MARK ]
Set or display the parity method for asynchronous symbols transmitted and received on
the front panel RS-232 serial console port.
13.2.5 C
UTOVER
...
The following are the commands relating to software cutover.
Oper1
CUtover Mode
[ OFF | TIMED | NOW ]
Set or display the cutover mode. A value of
OFF
means that cutovers are disabled,
TIMED
means that a cutover occurs at the below specified time (if dormant versions are
not the same as active versions),
NOW
means the cutover will occur immediately after a
software download occurs.
Oper1
CUtover Time
[YYYY/MM/DD HH:MM:SS ]
Set or display the cutover time.
Oper1
CUtover Version
[ version ]
Set or display the version to revert to in the event of cutover failure.
13.2.6 D
ISTRIBUTION
...
The following are the commands relating to the station page data distribution settings.
Oper1
DIstribution Portselect
[ ALL | SatRx | LAN ]
Set or display the distribution port selection. A value of
ALL
indicates that the
transmitter will accept valid MDP packets from all distribution ports. Any other setting
means that only the indicated distribution port can input MDP packets.
Oper1
DIstribution Hdlc Lowerlimitcrc
[ 0…100 ]
Set or display the distribution lower hysteresis CRC limit for good HDLC frames
received. The parameter is a percentage of good HDLC frames received.
Oper1
DIstribution Hdlc Upperlimitcrc
[ 0…100 ]