User Manual
Table Of Contents
- FOREWORD
- GENERAL OVERVIEW
- SPECIFICATIONS
- ELECTRICAL REQUIREMENTS
- SITE PLANNING
- INSTALLATION
- OPERATION
- POWERING UP THE SYSTEM
- CONNECTING A TERMINAL
- Bootloader
- *************************
- G2BT BOOTLOADER
- Version 2F49405
- *************************
- Current MAC address = 00:01:02:03:04:05
- Current IP address = 11.31.3.4
- Current subnet = 255.255.255.128
- Current gateway = 11.31.3.126
- Current TFTP Server = 10.0.0.1
- Current Download File = g2bt.pkg
- ***You've got 5 seconds to escape normal boot process by entering any key...
- Loading application...
- Application
- QUICK-START CONFIGURATION
- SUBSYSTEMS
- USER INTERFACES
- SW DOWNLOAD PROCESS
- POWER CONTROL
- COMMAND LINE USER INTERFACE
- ALARMS AND MANAGEMENT
- FACTORY DEFAULT VALUES
Sonik G2BT Base Transmitter User Manual
March 14, 2002 34 7M487C4
9
9
9
.
.
.
2
2
2
C
C
C
E
E
E
P
P
P
O
O
O
W
W
W
E
E
E
R
R
R
S
S
S
U
U
U
P
P
P
P
P
P
L
L
L
Y
Y
Y
The control chassis power supply has been designed by Mesa Power Systems. It has its own AC
power supply with provision battery-back-up for up to 15 minutes of operation. Internally, it uses
an
off-the-shelf AC-DC switching power converter. A simple micro-controller monitors the AC
supply, battery voltage and current, and battery charging. It communicates this status information
to the CPU via the SPI bus.
The back-up battery powers the control chassis, and does not power the RF power amplifiers, so
no RF output will be produced when operating off of the internal back-up supply. The internal
network interface will continue to operate off of the back-up supply.