User Manual

Sonik G2BT Base Transmitter User Manual
March 14, 2002 22 7M487C4
8
8
8
.
.
.
3
3
3
Q
Q
Q
U
U
U
I
I
I
C
C
C
K
K
K
-
-
-
S
S
S
T
T
T
A
A
A
R
R
R
T
T
T
C
C
C
O
O
O
N
N
N
F
F
F
I
I
I
G
G
G
U
U
U
R
R
R
A
A
A
T
T
T
I
I
I
O
O
O
N
N
N
All user configuration settings will have factory defaults set prior to shipment. However there
are several settings that are unique to each unit and must be configured in order for the
transmitter to function correctly in the field.
In order to change configuration settings, a “user session” must be created by logging into
the command line interface. To do this, connect a 9-pin DIN to the front panel RS232 port.
Using terminal emulation software (set at 9600 baud, 8 data bits, 1 stop bit, no parity), press
ENTER. At the login: prompt, type ADMIN, then press ENTER twice. An OK> prompt
should be seen.
The essential configuration settings are listed below. Go through, and configure each on for
the network that this device will be used in:
8.3.1 D
ISTRIBUTION
: I
NCOMING
MDP
CONFIGURATION
8.3.1.1 Network Zones (the zone number is a number between 0 and 65535)
DIstr Hdlc Net 1 xxx
8.3.1.2 Network Zone mask (the zone mask is a number between 0 and
65535)
DIstr Hdlc Net Mask yyy
8.3.2 T
RANSMISSION
: O
UTGOING
R
EFLEX CONFIGURATION
8.3.2.1 Tranmission Frequency (frequency is in MHz between 929.0 and
941.0)
TRAN Freq xxx.yy
8.3.2.2 Subchannel offsets (offset frequencies are in Hz between –20000
and 20000)
TRAN Sub 1 Config Freq xx
TRAN Sub 2 Config Freq xx
TRAN Sub 3 Config Freq xx
TRAN Sub 4 Config Freq xx
8.3.2.3 Launch Delay (in microseconds, this must be set to 203)
TRAN Launch 203