User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Installation RF-Baton! Transmitter Controller Installation and Operation
4-24 6880497G01-B June 1999
At the prompt, type:
a 111 <Enter>
The system responds:
RA 111
At the prompt, type:
a 113 <Enter>
The system responds:
RA 113
5. Set the subchannel offsets.
At the prompt, type
a1951231<Enter>
6. Set the center frequency.
At the prompt, type:
a 196 1 <Enter>
7. Begin the AM message data generation.
At the prompt, type:
a1760800011051<Enter>
Note: For a detailed description of all the parameters used to set up and initiate the test message
generation, see Chapter 5, "Operation", paragraph, "Test Data Mode".
Verifying the Paging Operation of the RF-B! Transmitter Controller
The following steps verify that the RF-B! transmitter controller is sending data and keying the
transmitter.
8. Verify that the front panel TX_OK LED (green) is On.
This indicates that the transmitter is ready to accept data from the RF-B! transmitter
controller. If the TX_OK LED is not lit, begin troubleshooting the transmitter.