User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Installation RF-Baton! Transmitter Controller Installation and Operation
4-22 6880497G01-B June 1999
5. Check the GPS receiver status for a value of 0x8.
At the prompt, type:
a 208 <Enter>
The system responds:
RA 208
# visible satellites = 8, # tracked satellites = 8 receiver status = 0x8
ID=1 Mode=8 SS=41 Status=0xa8
ID=14 Mode=8 SS=43 Status=0xa8
ID=15 Mode=8 SS=43 Status=0xa0
ID=21 Mode=8 SS=36 Status=0xa8
ID=22 Mode=8 SS=35 Status=0xa8
ID=25 Mode=8 SS=63 Status=0xa8
Note: This command displays the receiver status as well as satellite information. Only six satellites
are displayed despite the number of visoble or tracked satellites.
For a further explanation of the output of this action command, refer to the FIPS action
command table in Appendix C.
6. Wait one minute, then check the simulcast status by enabling the trace.
At the prompt, type:
a 192 SASM 4 <Enter>
The system responds:
RA 192
SASM pulse: State: <4> PAGING_WITH_GPS, 1PPS occurred : 1, 1PPS within window: 1
State: 4, pps_occured: 1, pps_within_window: 1
7. The RF-B! transmitter controller must be in State 4. Disable the trace.
At the prompt, type:
a 193 SASM 4 <Enter>
The GPS operation checkout is complete.