User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Installation
June 1999 6880497G01-B 4-17
6. Set the network address for each of the Simple Network Management Protocol (SNMP)
network managers (up to five).
At the prompt, type:
w 500 xxx.xxx.xxx.xxx <Enter> where xxx=0–255 decimal
w 501 xxx.xxx.xxx.xxx <Enter> where xxx=0–255 decimal
w 502 xxx.xxx.xxx.xxx <Enter> where xxx=0–255 decimal
w 503 xxx.xxx.xxx.xxx <Enter> where xxx=0–255 decimal
w 504 xxx.xxx.xxx.xxx <Enter> where xxx=0–255 decimal
7. Set the Trivial File Transfer Protocol (TFTP) server IP address according to the network
plan.
At the prompt, type:
a 301 xxx.xxx.xxx.xxx <Enter> where xxx=0–255 decimal
If your site is part of a multicast group, see Chapter 6, "Maintenance",paragraph, "Assigning
an RF-B! Transmitter Controller to a Multicast Group".
The network parameters are set.