User Manual

RF-Baton! Transmitter Controller Installation and Operation Installation
June 1999 6880497G01-B 4-9
Note: Appendix B lists the connector pinouts.
1. From the rear of the cabinet, open the cabinet door to access the backplane.
2. Connect the GPS antenna cable (Motorola part number 3080571S01) to the GPS ANT
connector (J22) on the RF-B! transmitter controller and the other end to the GPS connector
on the cabinet input panel.
Use a 3/8 in. open-end, back-up wrench and a 5/16 in. torque wrench calibrated to
6 in./lb to secure the connectors.
3. Connect the PnP cable (Motorola part number 3080508R03) to the PLUG N PLAY
connector (J4) on the RF-B! transmitter controller and the PLUG N PLAY connector (J4)
on the RF-O! transmitter.
Use a flat-blade screwdriver to secure the connectors.
Table 4-3: RF-B! Transmitter Controller Cabling Connections
RF-B!
Transmitter
Controller
RF-O!
Transmitter
Motorola Part
No.
Description
J4 J4 3080508R03 Plug-n-Play (PnP) Cable: DB25-to-DB25
J6 NA 3082750X01 Modem cable: DB25 Female
J9 NA
3086130G01 and
3086130G02
External GPS Input: DB25 Female
J11 J11 0112004Z03 Frequency Reference: BNC-to-BNC
J12 NA 3080508R04 Ethernet AUI: DB15 Female
J14 J15 3080609R09 DC Power Cable: +28 Vdc
J18 3080610R02 Battery Temperature: 3 PIN
J22 NA 3080571S01 Input from GPS antenna: 50 Ohm coaxial cable
GND NA 3082000X02 Ground wire: 16 AWG