User Manual

Installation RF-Baton! Transmitter Controller Installation and Operation
4-8 6880497G01-B June 1999
RF-Baton! Transmitter Controller Cabling
After installing the RF-B! transmitter controller, make the connections to the GPS antenna, RF-
O! backplane, and ground. Figure 4-3 shows the RF-B! transmitter controller connections.
Table 4-3 lists the connections and the type of cabling for each connection.
Note: The RF-B! transmitter controller can be used with other transmitters. For any other cabling
variations, refer to your local site documentation.
Figure 4-3: RF-B! Transmitter Controller Cabling (Rear View)
Tools
The following tools are required:
• 3/8 in. open end wrench
• 5/16 in. torque wrench
• 1/16 in. flat-blade screwdriver
DC INPUT
+ - + -
J19
AUX A+
J22
FAN
J15 PNP PWR
J21
DC IN
J20
DC IN
J11
EXT REF
J12
EXT LOAD TEMP
J4 PLUG-N-PLAY
J18
AUX 5V
PA#4 PA#3 PA#2 PA#1
J8 J7 J6 J5
J14
LOCAL COMM
J15
SYNC
J23
RF OUT
J23
RF FEEDBACK
J9 EXT WMTR
J17
FAN
GROUND
IN WMTR
J16
WILDCARD I/O
J8
BATT
TEMP
SWITCHED 28V
J20
DC INPUT
+ - + -
AUX
5V
AUX
A+
J15 J16
J13
FAN
J17
PSTN
J2
ETHERNET AUI
J4 PLUG N PLAY
J5
NETWORK COM
J8
J9
J7
J21 FAN
DISTRIBUTION
WILDCARD I/O
J22
LOCAL COMMJ19
GPS ANT
GPS OUT
GPS IN
J10
J6 MODEM
GROUND
705SRH-16
J11 RF-B! to
J11 RF-O!
J14 RF-B! to
J15 RF-O!
J4 RF-B! to
J4 RF-O!
RF-B!
RF-O!
To GPS
Antenna
Ground
RF-O!
To Ethernet
10baseT
Transceiver