User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Installation RF-Baton! Transmitter Controller Installation and Operation
4-6 6880497G01-B June 1999
RF-B! Transmitter Controller Installation Procedure
Perform the following steps to install the RF-B! transmitter controller into a typical EIA
standard 19-inch (48.26 cm) panel width cabinet.
Note: Perform Step 1 if the cabinet door does not open at least 90 degrees. Otherwise, go to Step 2.
1. Remove the front and rear cabinet doors (see, Chapter 6, "Maintenance", paragraph,
"Doors Removal")
2. Select an appropriate place within the cabinet for installation of the RF-B! transmitter
controller.
3. Unpack the RF-B! transmitter controller and the four T30 TORX screws.
4. Slide the RF-B! transmitter controller into the appropriate slot.
5. Align the RF-B! transmitter controller mounting holes with the cabinet mounting holes
and install the four T-30 TORX screws (see Figure 4-2).