User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Installation
June 1999 6880497G01-B 4-5
RF-B! Transmitter Controller Installation
This section covers the installation and hookup of the RF-B! transmitter controller with a
Motorola RF-Orchestra! (RF-O!) paging station.
Before installing the RF-B! transmitter controller into a cabinet, consider the position of the
RF-B! transmitter controller to the RF-O! transmitter. Ensure the RF-B! transmitter controller is
installed as close to the RF-O! as possible. Figure 4-1 shows the typical installation of the RF-B!
transmitter controller with the RF-O!.
Note: The space needed for the RF-B! transmitter controller is two EIA rack units (3.5 in. or
8.89 cm) high.
Figure 4-1: RF-B! Transmitter Controller and RF-O! Transmitter Installation Configuration
Tool
The following tool is required:
• TORX driver with T-30 bit
RESET
Control On
Control Fail
Disable
Alarm
Distribution OK
GPS Lock
RFB Req
TX OK
RF-Baton!™
Serial Port
POWER
RESET
Control On
Control Fail
Disable
Alarm
PA Keyed
Exciter Locked
Full Power
Pwr Ctbck
RF-Orchestra!™
Serial Port
Power
705SRH-12
RF-B!
RF-O!