User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Installation RF-Baton! Transmitter Controller Installation and Operation
4-4 6880497G01-B June 1999
Hardware Installation
Typically, the RF-B! transmitter controller is installed by the factory in the same cabinet as the
transmitter. This section provides information related to installing a separately shipped RF-B!
transmitter controller into a cabinet.
The information provided in this section is for the installation and cabling of the RF-B!
transmitter controller with the Motorola RF-O! paging station and the Motorola OncoreVP
GPS receiver. The RF-B! transmitter controller can, however, also be used with different
transmitters and GPS receivers, which may change the cabling layout. For these speciļ¬c
cabling variations, refer to your local site documentation.