User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation System Description
June 1999 6880497G01-B 2-19
J14 BATT +28 Vdc input and optional battery revert connection for batteries
J15 AUX 5V Auxiliary +5 Vdc source
J16 AUX A+ Auxiliary +12 Vdc source
J17 PSTN Optional internal public switch telephone network connection
J18 BATT TEMP Input from battery temperature sensor with the optional battery installed
J19 AIPS PORT Development use only
J20 SWITCHED 28V Auxiliary +28 Vdc source controlled by the BCM—used for external GPS
receiver power
J22 GPS ANT (Coaxial) RF signal input from antenna using SMA connector.
Note: Center conductor has +5 Vdc applied when the optional GPS
receiver is installed in the RF-B! transmitter controller.
Table 2-3: RF-B! Transmitter Controller Backplane Connectors—J1 through J22 (Sheet 2 of 2)
Connector. Name Description