User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
E-10 6880497G01-B June 1999
Traces RF-Baton! Transmitter Controller Installation and Operation
E-10 6880497G01-B June 1999
OPPM 0x00000004 4
OPP Manager Task PDM Trace—
quickly displays the contents of each
PDM successfully received by the RF-B!.
NOTE: Paging Enable does NOT have to
be in effect for this trace to run. That is,
the ethernet front end is always
operational, regardless of the state of
paging.
This trace can be used on a continuous
basis to verify PDM content.
PdmData { } = ReflexOpp
Time { } = 34 : 15 : 0
PdmApdu { } =
rfChannelIndex = 0
subchannel = 0
OPPM 0x00000008 8 OPP Manager Task Output Disable
Command—this command disables the
output of the OPP manager, thus the
rest of the paging control tasks do not
execute. This cmd can be used in
conjunction with OPPM 4 to look at PDM
data without transmitting it over the air.
No output
TASK MASK
FLAG
(dec)
DESCRIPTION EXAMPLE OUTPUT