User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
June 1999 6880497G01-B C-7
RF-Baton! Transmitter Controller Installation and Operation FIPS Action Commands and Parameter IDs
June 1999 6880497G01-B C-7
140 Test ADPCM Training
(
Version 1.2.1+
)
Test training on various DSPs a 140 x (where x is 0,1,2,3) Requests training on one of the 4
DSPs(0,1,2, or 3). The first byte of the
returned message will display 00, if
training request was successful
Used for Development Testing Only.
141 Enable or Disable
ADPCM Training
(
Version 1.2.1+
)
Enables or Disables ADPCM
Training
a 141 x
(x=0, disables training, x=1,
enables training)
This command enables and disables
training for testing purposes. Training is
enabled by default after power-up reset. If
training is disabled, it will be re-enabled
after a reset, or after the “enable”
command is sent.
Used for Development Testing Only.
Table C-1: FIPS Action Commands
Action Name Description Usage Response