User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation / Appendix B
June 1999 6880497G01-B B-1
Connector Pinouts B
Serial Port
The RF-B! transmitter controller serial port, located on the front panel, is used for obtaining
station parameter and diagnostic information through a service terminal. The serial port uses
RS-232 signaling through a DB-9 female connector. Table B-1 provides the pinout information
for the Serial Port.
Note: The Console port requires the data carrier detect (DCD) pin to detect that a serial cable is
connected. Ensure that your serial interface and cable properly provide DCD.
Table B-1: Console Port Connector
Pin Signal
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 Not used
7 Not used
8 Not used
9 Not used