User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-55
Initializing New Parameters
If you did not reset the Parameter Database and you are upgrading from RFB 1.1.0 or earlier
RF-B! transmitter controller software, you must perform the following procedure:
1. Connect a service terminal to the RF-B! transmitter controller (see Chapter 5, "Operation",
paragraph, "Service Terminal").
Note: Keyboard conventions were previously described (see Chapter 1, "Introduction", paragraph,
"Keyboard Conventions".)
2. Set the maintenance path (RF-O! transmitter and RF-B! transmitter controller) to 9600
baud.
At the prompt, type:
w 213 4 <Enter>
Note: This parameter was added in revision 1.2.0.