User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-54 6880497G01-B June 1999
11. Gently place the BCM into the slot in the RF-B! transmitter controller chassis, firmly
seating the board card-edge connectors into the backplane (see Figure 6-11).
12. Install the RF-B! transmitter controller faceplate (see paragraph, "Faceplate Installation").
13. Set the RF-B! transmitter controller POWER switch to ON (|).
Note: The RF-B! transmitter controller networking parameters that were initialized during the
installation procedure are maintained during a parameter database update. All other
parameters are reset to a default condition, including software download parameters.
The parameter database is set.