User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-52 6880497G01-B June 1999
Resetting the Parameter Database
Reset the parameter database after software upgrades.
Perform the following procedure to reset the parameter database:
1. Set the RF-B! transmitter controller Power switch to OFF (O) (see Figure 6-10).
Figure 6-10: RF-B! Transmitter Controller Front Panel
2. Remove the RF-B! transmitter controller faceplate (see paragraph, "Faceplate Removal").
3. Gently pull the BCM straight out (see Figure 6-11).
Figure 6-11: RF-B! Transmitter Controller (Front Panel Removed)
RESET
Control On
Control Fail
Disable
Alarm
PA Keyed
Exciter Locked
Full Power
Pwr Ctbck
RF-Orchestra!™
Serial Port
302SRH 13
Power
POWER Switch
705SRH-09
DC-DC Converter
RF-Baton! Control ModuleReference Module
Power Switch