User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-50 6880497G01-B June 1999
4. Change the IP address to the correct IP Address of the TFTP Server.
At the prompt, type:
A 301 [xxx.xx.xxx.xx] <Enter> (where xxx... is the IP address of the TFTP server)
5. Start the download.
At the prompt, type:
A 310 <Enter>
The second light-emitting diode (LED) from the right (RFB Req LED) flashes to indicate
the file is being programmed into the FLASH memory.
The download time is approximately 5 minutes.
When the RFB Req LED stops flashing, wait 30 seconds before going to Step 6.
6. The new software is now loaded into the dormant FLASH bank. Switch the software to
the active bank.
At the prompt, type:
A 312 <Enter>
The RF-B! transmitter controller should reboot. The second LED from the left (Control
On) lights indicating the cutover is complete.
7. Verify the active software version.
At the prompt, type:
R 148 <Enter> (Read Active Flash bank)
The RF-B! returns the active software version.
8. Check the dormant FLASH bank.
At the prompt, type:
R 152 <Enter> (Read Dormant Flash bank})
The RF-B! returns the dormant software version.
Note: See paragraph, "Parameter Database Updating" to determine whether any updates to the
parameter database are necessary.