User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-49
Local Software Download Procedure
Perform the following steps to perform the local software download:
1. Connect the service terminal to the RF-B! transmitter controller (see Chapter 5,
"Operation", paragraph, "Service Terminal").
Note: Keyboard conventions were previously described (see Chapter 1, "Introduction", paragraph,
"Keyboard Conventions".)
2. At the FIPS prompt, type:
A 300 <Enter>
The following information should appear on the display:
3. Enter the correct file name of the S-record to be downloaded.
At the prompt, type:
A 302 [filename] <Enter> (where [filename] is the S-record file stored in the
/tftpboot directory of the TFTP server)
FIPS:
Current tftp parameter configuration:
TFTP server IP address: <tftp server IP address>
remote file name : rfb1
Commands to proceed further:
a 310 to start download to RFB
a 312 to switch over to dormant banK
a 301 xx.xx.xx.xx to set TFTP Server IP address
a 302 file name to set TFTP download file
NOTE: 8 characters MAXimum