User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-42 6880497G01-B June 1999
8. While supporting the battery assembly, remove and save the four #30 TORX screws and
remove the battery assembly (see Figure 6-9).
6-Hour Battery Installation
Perform the following steps to install the 6-hour battery assembly:
1. From the back of the cabinet, position the 6-hour battery assembly with the wires on the
left side.
2. Align the bracket holes on the battery assembly with the chassis holes and install the four
screws removed in paragraph, "6-Hour Battery Removal", Step 8 (see Figure 6-9).
3. Connect the connector with two wires to J15 on the OCC and tighten the screws (see
Figure 6-8).
4. Connect the connector with four wires to J14 on the BCC and tighten the screws.
5. Anchor the wires to the chassis rail using a wire tie (see Figure 6-9).
6. Install the fuse).
7. If necessary, install the rear cabinet door (see paragraph, "Doors Installation").
8. From the front of the cabinet, set the AC power supply power switches to ON (|) (see
Figure 6-7).
9. Set the RF-O! transmitter POWER switch to ON (|) (see Figure 6-7).
10. Set the RF-B! transmitter controller POWER switch to ON (|).
11. Check system operation (see Chapter 4, "Installation", paragraph, "Operational
Checkout").
DANGER
The 6-hour battery assembly weighs 40 pounds. One person must
support the battery assembly while the other person removes the
screws to prevent injury to personnel, damage to the equipment, or
both.