User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-41
6. Loosen the two screws securing the connector to J15 on the orchestra control
chassis (OCC) back panel (see Figure 6-8).
Disconnect the connector.
7. Remove the wire tie that secures the wires to the chassis (see Figure 6-9).
Figure 6-9: 6-Hour Battery Assembly (Installed)
DC INPUT
+ - + -
J19
AUX A+
J22
FAN
J15 PNP PWR
J21
DC IN
J20
DC IN
J11
EXT REF
J12
EXT LOAD TEMP
J4 PLUG-N-PLAY
J18
AUX 5V
PA#4 PA#3 PA#2 PA#1
J8 J7 J6 J5
J14
LOCAL COMM
J15
SYNC
J23
RF OUT
J23
RF FEEDBACK
J9 EXT WMTR
J17
FAN
GROUND
IN WMTR
J16
WILDCARD I/O
J8
BATT
TEMP
SWITCHED 28V
J20
DC INPUT
+ - + -
AUX
5V
AUX
A+
J15 J16
J13
FAN
J17
PSTN
J2
ETHERNET AUI
J4 PLUG N PLAY
J5
NETWORK COM
J8
J9
J7
J21 FAN
DISTRIBUTION
WILDCARD I/O
J22
LOCAL COMMJ19
GPS ANT
GPS OUT
GPS IN
J10
J6 MODEM
GROUND
510SRH-17
6-Hour Backup Battery Assembly
Ferrite Bead
TORX Screws
(each side)
Fuse
Wire Tie
Chassis Rail