User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
Maintenance RF-Baton! Transmitter Controller Installation and Operation
6-40 6880497G01-B June 1999
Note: Perform Step 4 if the cabinet door does not open at least 90 degrees. Otherwise, go to Step 5.
4. Remove the rear cabinet door (see paragraph, "Doors Removal").
5. Loosen the two screws securing the connector to J14 on the baton control chassis (BCC)
back panel (see Figure 6-8).
Disconnect the connector.
Figure 6-8: Rear View of BCC and OCC
DC INPUT
+ - + -
J19
AUX A+
J22
FAN
J15 PNP PWR
J21
DC IN
J20
DC IN
J11
EXT REF
J12
EXT LOAD TEMP
J4 PLUG-N-PLAY
J18
AUX 5V
PA#4 PA#3 PA#2 PA#1
J8 J7 J6 J5
J14
LOCAL COMM
J15
SYNC
J23
RF OUT
J23
RF FEEDBACK
J9 EXT WMTR
J17
FAN
GROUND
IN WMTR
J16
WILDCARD I/O
J8
BATT
TEMP
SWITCHED 28V
J20
DC INPUT
+ - + -
AUX
5V
AUX
A+
J15 J16
J13
FAN
J17
PSTN
J2
ETHERNET AUI
J4 PLUG N PLAY
J5
NETWORK COM
J8
J9
J7
J21 FAN
DISTRIBUTION
WILDCARD I/O
J22
LOCAL COMMJ19
GPS ANT
GPS OUT
GPS IN
J10
J6 MODEM
GROUND
705SRH-15a
DC INPUT
+ - + -
J22
FAN
J15 PNP PWR
J14 DC INPUT
+ - + -
AUX
5V
AUX
A+
Baton Control Chassis
Orchestra Control Chassis