User Manual
Table Of Contents
- Foreword
- PSG Limited Equipment Warranty for U.S. And Canadian Markets
- PSG Limited Equipment Warranty for NonU.S. and Non-Canadian Markets
- Introduction 1
- System Description 2
- The Wireless Messaging System Overview
- FLEX, ReFLEX and InFLEXion Messaging Protocol Overview
- RF-B! Transmitter Controller Functional Description
- RF-Baton! Transmitter Controller Specifications
- Preinstallation 3
- Installation 4
- Operation 5
- Maintenance 6
- Troubleshooting
- Data Path Diagnostics
- GPS Diagnostics
- Removal and Installation
- Assigning an RF-B! Transmitter Controller to a Multicast Group
- Remote Software Download from Choreographer! Network Manager
- Local Software Download Using the Front Panel
- Parameter Database Updating
- Abbreviations and Acronyms A
- Connector Pinouts B
- FIPS Action Commands and Parameter IDs C
- Alarms and Error Messages D
- Traces E
RF-Baton! Transmitter Controller Installation and Operation Maintenance
June 1999 6880497G01-B 6-37
Baton Control Module
Perform the following procedures to remove and install the Baton Control Module (BCM).
BCM Removal
Perform the following steps to remove the BCM.
1. Remove the RF-B! transmitter controller faceplate (see paragraph, "Faceplate Removal").
2. Unplug the BCM from the RF-B! transmitter controller chassis (see Figure 6-6).
3. Gently pull the BCM straight out and set aside.
BCM Installation
Perform the following steps to install the BCM.
1. Gently place the new BCM into its slot in the RF-B! transmitter controller chassis, firmly
seating the board card-edge connectors into the backplane (see Figure 6-6).
2. Install the RF-B! transmitter controller faceplate (see paragraph, "Faceplate Installation").
Reference Module
Perform the following procedures to remove and install the reference module.
Reference Module Removal
Perform the following steps to remove the reference module.
1. Remove the RF-B! transmitter controller faceplate (see paragraph, "Faceplate Removal").
2. Unplug the reference module from the RF-B! transmitter controller chassis (see
Figure 6-6).
3. Gently pull the reference module straight out and set aside.